Siser Metal HTV Me
$7.00
$14.50
By DivineBlanks
Siser Metal HTV
Your Creations will stand out with this beautiful smooth Shiny HTV
Measurements : 30cm by 1 meter
Please Note: Orders cut to size .
Metal Cutter Settings |
Cricut: Blade: Standard Setting: Iron-on
|
Silhouette Cameo: Blade: Standard, 2 Material:Heat Transfer, Smooth Speed: 8 Force: 4
|
Brother ScanNCut: Blade: Standard, 2 Cut
Speed: 1 Cut Pressure: 3 |
Roland GX/GS-24: Blade: 45° Gram Force: 80-90 Offset: .250 Speed: 30-50 cm/s
|
Graphtec: Blade: 45° Force: 8-9 Tool: CB09U+0 Speed: 30 cm/s
|
MH, SC2, LP3, and Titan1: Blade: 45°/60° Gram Force: 85-90 Speed: 300 mm/s
*Blade Advancing Varies |
Titan 2 & 3: Blade: 45°/60° Gram Force: 65-70 Speed: 300 mm/s
*Blade Advancing Varies
|
Application Settings (Home Iron) |
• Set iron dial between Cotton and Linen • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 10-15 seconds • If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds • Peel carrier cold * Layerable as the top layer only |
Application Settings (Heat Press) |
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Preheat garment for 2-3 seconds • Apply design at 305°F/150°C • Use medium pressure for 10-15 seconds • Peel carrier hot or cold * Layerable as the top layer only
|